A great alternative to embroidery,StripFlockPro heat transfer vinyl gives logos a raised, textured, suede-like feel. The fuzzy opaque colors makeStripFlockPro excellent for retro designs like youd find in a mall in the 80s, or anytime you want a deep, rich look.StripFlockPro is thick enough to cover hat seams, yet also looks excellent on bags, denim, and other garments that need textured visual interest. UseStripflock Proas a base layer and cover with other materials such asEasyWeed Stretchfor an embossed look, or layer with moreStripFlock! The ability to layer this material with itself and others allows you to say yes to multi-color designs. However, please note that for best results all fluorescent colors are recommended to be layered with the knockout method and the carrier peeled warm.

StripFlockPro is 410 Microns / 16.1 mils and is a PVC composition.

Applies to:

• 100% cotton
• Poly/cotton blends
• 100% polyester
• Leather

Application instructions (home iron)

Set iron dial between Cotton and Linen
Cover design with Kraft paper or non-stick cover sheet
Place on flat, hard surface (ironing board not recommended)
Press iron with medium/firm pressure (do not slide iron)
Press each section of design for 15 seconds
If areas of design lift after application, replace cover sheet
and re-press for 10 seconds
Peel carrier warm

Application Instructions (heat press)
Cut in reverse
Weed excess material
Preheat garment for 2-3 seconds
Apply design at 311F/155C
Use medium pressure for 15 seconds
Peel carrier warm ( at least 10 seconds off press)